Table of Contents
What does the water separator do on a diesel engine?
A fuel water separator not only helps to remove contaminants and debris from your fuel before it reaches the engine, it also removes any water found in your fuel. As fuel enters the fuel water separator, it passes through a filter media (typically a 10 micron fuel filter water separator).
Do diesel trucks have water separators?
Diesel fuel can easily become contaminated by water because diesel fuel absorbs water more than gasoline does. For this reason, many diesel vehicles feature a gadget called a water separator that collects water from the fuel. It’s usually located on or near the fuel filter.
How often should the fuel water separator be replaced?
Re: Fuel Water Separator – when to change filter? On my old boat I always changed mine every six months. I installed two RACORs (with the clear strainer bottom) on my new boat and I’m gonna do them once a season… I would definitely replace them whenever you do your motor maintenance at least..
How often should you change fuel filter on 6.4 Powerstroke?
6.4L Diesel Suggested Maintenance
- Oil and Filter – Oil change service intervals should be completed as indicated by the instrument cluster message center or every 7500 miles.
- Fuel Filter Change – Change every 3rd oil change or every 15,000 miles(36,00 km) or as indicated by the message center which ever comes first.
What happens when fuel water separator gets full?
The buildup of water stops the fuel filter from separating out the bad particles in your fuel. These particles will build up in your fuel system and engine causing damage to those components. The best way to fix this issue is to make sure you replace this part as needed.
How can I make my 6.4 Powerstroke reliable?
13 Best 6.4L Powerstroke Performance Upgrades
- Performance Monitors & Digital Gauges.
- Engine Coolant Filtration Systems.
- Aftermarket Radiators.
- Tuners & Programmers.
- Cold Air Intakes.
- Replacement Up-Pipes.
- Aftermarket Intercoolers.
- Exhaust Systems.
What happens if you don’t drain the fuel water separator?
Water buildup in the water separator that isn’t drained will cause corrosion to the housing. This corrosion will spread to different parts of your fuel system including the engine. A simple fix is to drain this water when the “Water in Fuel” light illuminates and periodically install a new secondary fuel filter.
What happens when water separator is full?
A full water separator means that water is now flowing into your fuel system. This water causes corrosion throughout the system including the internal transfer pump. This pump will then rust and isn’t covered under warranty.
How long does a fuel water separator last?
If you use gas w/ ethanol, you are bound to get some water in your fuel. Don’t know what type of engine you have but Yamaha recommends every 50 hours. I agree with Bunger79 until you consistantly have a clean filter, then I would go to 100 hours.
How do I know if my fuel water separator is bad?
Hesitating Engine With Heavy Load If your fuel filter water separator isn’t working properly or is clogged, then water and other pollutants could be mixing into the fuel injector and causing damage inside your engine. You’ll also know there’s an issue if the check engine light switches on.