Table of Contents
How do I reset my Hobart dishwasher?
If they are, try resetting the machine by doing either of the following:
- Option 1. Press the WASH key again while the wrench and “empty chemical” icon flashing.
- Option 2. Turn the machine off and wait about 10 seconds before turning it back on.
How do I prime my Hobart LXI?
Once a chemical empties a Hobart LXe series dishwasher, he machine begins to automatically prime the chemical pumps whenever it’s turned back on or starts a wash cycle. The priming process occurs for one minute in the detergent, rinse agent and sanitizer pumps.
How often should you Delime a Hobart dish machine?
The Centerline is set at the factory to delime after 1,500 cycles, but how often you should delime really depends on the hardness of your water. The deliming cycle should be run when you see a white chalky substance on the inside walls of the dishwasher.
How often should you Delime a dish machine?
0. It’s generally recommended that you run a descaling cycle (or deliming cycle) once every week. Switch your machine into deliming mode and add deliming solution (consult your user’s guide, or speak with your supplier/manufacturer for details on safe deliming solutions for your equipment).
How long is a Delime cycle?
Let your machine fill and heat up. Put approximately 10oz of descaler into the machine and leave it for 1 hour. Run a few wash cycle so it can clean all the jets. Once this is done drain the machine out also flush it with fresh water.
How do I reprogram my Hobart dishwasher?
(If the dishwasher needs to be reprogrammed, contact your local Hobart authorized service office.) 1. Remove rack from machine. Close door. 2. Press OFF to power down the dishwasher.
What kind of dishwasher is the LXI series?
The LXi Series dishwashers are fully automatic, front-loading dishwashing machines that are capable of 30 racks per hour. All LXi Series dishwashers shut down automatically 4 hours after last use to conserve energy. All LXiH and LXiGH dishwashers include Sense-A-Temp™ to insure proper hot water temperature during rinse.
What should I do if my Hobart dishwasher displays E6?
If problem persists, contact your local Hobart Service Office. Some water occasionally drips out of rinse arms (H dishwashers only). This is normal due to expansion of water being heated in the booster tank. Machine displays E6. Contact your local Hobart Service Office.